SmartThings and GE 45631 Z-Wave Wireless Keypad Controller

zwave-remote

This device provides control of 4 Groups and 4 Scenes.
Up to 32 Z-Wave devices can be included in each of the
Groups and Scenes. It is a secondary controller only and
cannot function as a primary controller.
Associate a device to the remote
1. Press and hold the Add and Remove buttons at the same time
until the Orange LED blinks twice, then release
2. Press and release the Add button.
3. Press and release the Group button.
Press and release the right side (ON) of the Group/Scene
button (1, 2, 3 or 4) that you want to assign the device to. The
Orange LED will start blinking.
Press and release the button on the device you wish to add.
The Green LED will blink twice to show that you have
successfully Added a device to a Scene

SmartThings and GE Jasco Remote 45600

 

ZWave remote integration into SmartThings networkGE 45600

RESET THE REMOTE

Remote [Hold Setup] : RED/GREEN LED flash twice
Remote [969] : GREEN LED flashes twice.

ADD Remote to SmartThing network

SmartThings APP: [+] [+ Connect New Device] -> Searching…
Remote: [Hold Setup] : (RED/GREEN LED blink twice)
Remote: [967] : (GREED LED rapid blink) till the connection
SmartThings APP: Complete the installation naming the device

ADDING A LIGHT (DEVICE / NODE) TO YOUR REMOTE

The “light (aka power switch)” must already be part of the SmartThings infrastructure.
You can add a maximum of 18 lights to your remote so that they can be controlled individually.

The devices should always be reset  prior  new ‘inclusion’:

Remote: [Hold Setup] until both the RED/GREEN LEDs blink twice.
Remote: [DELETE] (Red Blink)
Remote: [Light] (flashes green rapidly).
Device: [configuration button] reset is complete when green stops flashing.
(the  green led blink 2 time faster as succes confirmation feedback).
Remote: [hold SETUP] until both the RED/GREEN LEDs blink twice.
Remote: [ADD] once. (RED LED blinks once)
Remote: [LIGHT] once. (RED LED blinks once)
Remote:  Press a digit [1…9] (GREEN LED blinks rapidly)
for the device button you wish to add.
Press SHIFT and the digit [1…9] if you are adding devices 10 through 18. 
Device: [configuration button] on the device so that it sends its information to the remote and receives information from the remote.
When the GREEN LED blinks twice, you have successfully added the device to your remote control.
NOTE: If the RED LED emits one long, steady blink, you have pressed an invalid key or the device has not been successfully added to your remote.
Please make sure the remote is within two feet of the device and try again.

Complete list of the 45600  “magic key sequences”:

0969 reset
0967 add this controller as primary/secondary controller (LEARN)
09661 add another secondary controller (device and network information)
09662 add another secondary controller (network information only)
09681 make another remote primary controller (device and network information)
09682 make another remote primary controller (network information only)

To activate the above MKS press and hold the SETUP key until both the red and green LEDs blink twice before typing the code.